How do I secure this motorcycle in my pickup truck? - pickup truck pictures
I have a Yamaha YZF600R
http://albuquerque.craigslist.org/mcy/63 ...
for the transportation of 177 miles on the back of my truck
1995 Toyota Tacoma Extended Cab
http://www.edmunds.com/toyota/tacoma/199 ...
How do I do that?
Sunday, January 24, 2010
Pickup Truck Pictures How Do I Secure This Motorcycle In My Pickup Truck?
6 comments:
My grandchildren every weekend dirt bikes - motocross - go port of loading or a business that sells bracelets necktie ---- see whether the truck has anchors at each corner of the box - if not do - someone capable --- to hold the hook on the right handlebar anchor --- After a rather - shall fix the belt ---- then on the left side - - to stop and turn right - these tapes usually only costs about 8 $ each need two straps --- --- run the front wheel against the box - in the middle of the box ----
I want to use tie-downs in the 4 corners to go so far. You can go everywhere. The type of work, Ratchet alittle better, I think.
You will not be able to use a permanent place in the bars. You need a harness bar http://www.1tail.com/sa/p/CANYON_DANCER_ ...
Even with 2 periodic closures on the back of the bike and make sure the bike is in neutral.
Sportbike with the lower deck is almost on the floor and have a ramp at an angle normal that you are not the bike without touching the ground push the casing allow.
There are ramps with a hump in the middle to prevent it, or if you experience any of them have prevented, you must have at least 3 people to load the bike. 2, the bike on the ramp, slide, lift the third on the back of the ramp when the front wheel on the back door, and before the successful docking.
If no moorings in the bed and no post-game, then you must run the bed referral to the underside of the vehicle - but I think you will find that there are positions within the game in bed, you can.
Another option is to rent or borrow MotorcycThe semi-trailer. However, you must take the helm, but you are not afraid of difficulties in loading and unloading of truck wheels.
2 files, or ratchet straps,
Hooks on the front fork tubes just below the clip three times as high as you can in each hand
Mount ratchet straps, while the handlebars, and you will lower the front suspension, the suspension of the belt leaving too tight
If you put it to bed with the door closed adjustment until a 2X6. Do not forget the rear wheel on the board strap. This will prevent the tire from slipping. You also need the tail of the board on the back of his truck structure. I wore a 97 HD Road King in a Ford Ranger 500 miles without any problems.
PS You know that you also ensure your bike on the truck. 4 points piont. Ratcha is safer than the bra.
4 belts, should be able to do so. You can put a piece of wood that has notches around the wheel arches at the rear edge to the corners and move the tire bolt.
Post a Comment